Build a Base That Holds

Gravel Placement and Grading Services

Your driveway or lot needs a stable foundation that drains properly and resists shifting under weight. Without the right subbase and compaction, gravel spreads unevenly, creates ruts, and traps water that weakens the surface over time. Warner Trucking Corporation provides gravel placement and grading to prepare your property with layered rock that stays in place season after season.

This service involves placing subbase rock as the structural layer, followed by base rock for stability, and finished rock for the surface you drive or walk on. Heavy rollers compact each layer to remove air pockets and lock the material into a dense, load-bearing foundation. Drainage grading ensures water flows away from structures and off the surface instead of pooling in low spots.

If you need a driveway, parking area, or access road built to handle regular use, reach out to discuss your site conditions and the rock layers that work best for your terrain.

Layered Rock Placement That Resists Settling

The work begins with subbase rock, which forms the bottom layer and distributes weight across the ground below. Base rock is spread next to create a firm middle layer that locks into the subbase. Finished rock is placed on top as the visible surface that vehicles contact. Each layer is compacted with rollers that apply consistent pressure across the entire area, removing voids and increasing density.

After grading and compaction, you will notice a firm surface that does not shift under tires or foot traffic. Water runs off to the sides instead of collecting in the center, and the edges remain defined without material migrating into surrounding soil. The finished surface holds its shape through freeze-thaw cycles and wet weather because the layers beneath are compacted to resist movement.

Drainage grading adjusts the slope of the finished surface to direct runoff toward designated drainage areas or away from buildings. This service does not include paving, asphalt overlay, or decorative stone features. The grading is designed to support vehicle traffic and maintain surface integrity under typical residential or light commercial use.

Homeowners often ask about compaction methods, drainage setup, and how each rock layer contributes to the final surface. These questions help clarify what the service includes and how the materials perform over time.

Questions Come Up When Planning New Groundwork

What does compaction with rollers accomplish?
Rollers apply weight that presses gravel particles together, removing air pockets and creating a dense layer that resists shifting. Compacted gravel supports vehicle weight without developing ruts or soft spots.
How does drainage grading prevent water from pooling?
Grading adjusts the slope so water flows off the surface toward drainage areas instead of collecting in low spots. Proper slope keeps the surface dry and reduces erosion along the edges.
What is the difference between subbase, base, and finished rock?
Subbase rock is the bottom layer that spreads weight across the ground, base rock forms the middle layer for stability, and finished rock is the top surface layer. Each layer has a specific particle size and compaction requirement.
How long does it take for the gravel to settle after placement?
Properly compacted gravel settles very little after placement because the roller removes most air gaps during installation. You can use the surface immediately after compaction is complete.
When should I consider adding more rock to an existing area?
Add more rock if you notice ruts forming, exposed subgrade, or standing water that does not drain. These signs indicate the surface layer has worn thin or the base needs reinforcement.

Warner Trucking Corporation uses layered placement and roller compaction to build surfaces that hold up under regular use and direct water away from your property. If you are planning a new driveway or lot, contact us to review your site and discuss rock specifications.